4 x 500 kVa  415 Volt 50 Hz  Open Skid Mounted Diesel Generators For Australia Mining Project

For such a diesel generator running  for mining worksite, our engineers  select below parts fitted on the disel generator sets to make sure  it runs 24 hours and non stop.

We select the USA Cummins diesel engine QSX15-G8 and Stamford Alternator, benefits the reliable and durable.

Each Generator needs have these parts:

1. 4 x Deep Sea DSE 8610 Controllers.

2. 4 x Racor 1000 series Fuel/Water Separators.

3. 4 x  Mann & Hummel FM 200 Centrifugal Oil Cleaners.

4. 4 x 12 Volt Sump Drain Pumps.

5. (Easier to remove the Oil for service purposes).4 x Low Coolant level sensors.

6. 4 x Fuel Coolers.

7. (To cool the return fuel prior to entering the supply Fuel Tank).

8. 8 x Maintenance free Deep Cycle Batteries

9. These engines all need to have rust prevention treatment prior to shipping of units, to prevent any oxidation during transit to Australia.

10. Any "special" tooling required for the maintenance of these engines, i.e, (Front and Rear Crankshaft Seal removal and installation tools, and Camshaft timing Wedges).

11. 1 x spare DSE 8610 Controller.

12. 1 x spare programmed ECM.

13. Engine software and communication data to monitor engines during operation.

14. 1 x Complete Engine Workshop Manual.